My Business – ASTM F/ FM Stainless Steel Bolts / Screws / Studs Manufacture of Stainless Steel Metric Bolt, Screw & Stud ASTM FM – 02( ). ASTM Standards: A Specification for Stainless Steel Bars and Shapes2. A /A M Test Methods for Permeability of Feebly. Magnetic Materials3. 1 May ASTM FM() [ Withdrawn ]. Standard Specification for Stainless Steel Metric Bolts, Screws, and Studs (Withdrawn ). standard by.
|Published (Last):||12 November 2017|
|PDF File Size:||2.79 Mb|
|ePub File Size:||16.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
ASTM F738 Specification
Stay on Page Continue to Compass. This standard is being withdrawn without replacement due to its limited use by industry.
Tensile strength, yield strength, elongation, and torsional strength shall be tested to meet the requirements prescribed. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
This standard does not purport to address the safety problems associated with its use. This specification covers the chemical and mechanical requirements for stainless steel metric bolts, screws, and studs with nominal thread diameters M1. The chemical and mechanical requirements specified for all property classes, except as given in 1.
This specification covers the material, dimensions, and construction of 5 and gal 20 asrm L tanks purchased satm store and dispense lubricating oils.
The property classes with the permissible alloys for each are listed in Table 1. Eight groups of stainless steel alloys are covered, including three austenitic grades A1, A2, and A4one ferritic grade F1three martensitic grades C1, C3, and C4and one precipitation hardening grade P1.
Superfast Fasteners India Pvt. The tanks are industrial safety cans mounted on a T-bar bracket, complete with drip tray.
No other units of measurement are included in this standard.
Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The chemical and mechanical requirements specified for all property classes, except as given in 1. This standard does not purport to address the safety problems associated with its use.
There should be no visible seam leakage when subjected to underwater or soap bubble test. Formerly under the jurisdiction of Committee F16 on Fasteners, this specification was withdrawn in December I Washers Manufacture of D.
Internal air pressure test shall be performed on f7738m tank to meet the requirements prescribed. Link to Active This link will always route to the current Active version of the standard.
ASTM F Specification – Boltport Fasteners LLP
No other units of measurement are included in this standard. The property classes with the f7338m alloys for each are listed in Table 1. The chemical composition of the material shall conform to the requirements prescribed.
It is the responsibility of the user of this standard to establish appropriate safety and ff738m practices and determine the applicability of regulatory limitations prior to use.